Assembly - Honda BF135A Manual

2. ASSEMBLY

CHAIN CASE ASSEMBLY:
1) Apply soapy water to the outer surface of a new 43 x 58 x
7 mm oil seal.
Using the special tools, drive in the 43 x 58 x 7 mm oil seal
until it seats on the chain case as shown.
After installation, apply grease to the oil seal lip.
TOOLS:
Driver
Attachment, 52 x 55 mm
2) Remove the old liquid gasket, oil and contamination from
the chain case cover and the chain case mating surfaces.
3) Apply a bead [ø2.0 – 3.0 mm (ø0.08 – 0.12 in)] of the liquid
gasket (ThreeBond ®
area of the chain case cover.
NOTICE
Assemble the chain case cover within 5 minutes after
application of the liquid gasket. If it has been left for 5
minutes or longer, remove the old liquid gasket and apply
the liquid gasket again before assembly.
9-9
07749-0010000
07746-0010400
#1280B or equivalent) to the indicated
[1] <Oil seal installation direction>
[2] (Apply grease
to the lip.)
[3] OIL SEAL
[1] Apply a bead of liquid
gasket as shown.
[4]
DRIVER
07749-0010000
[5]
ATTACHMENT,
52 x 55 mm
07746-0010400
[3] OIL SEAL