Remote Control Box Location; Remote Control Cable Length - Honda BF250A Owner's Manual

INSTALLATION
<Remote Control Box Location>
REMOTE
CONTROL
LEVER
REMOTE
CONTROL BOX
Install the remote control box in the
position where is easy to operate the
remote control lever and switches. Be
sure that there are no obstacles on the
route of the control cable.
The control box position of the R2
type and the R3 type should be
determined in the same manner.
38
<Remote Control Cable Length>
REMOTE
CONTROL
CABLE
Measure the distance from the control
box to the outboard motor along the
cable routing.
Recommended cable length is
300 – 450 mm (11.8 – 17.7 in) longer
than the measured distance.
Set the cable along the predetermined
route and be sure that it is long
enough to the route.
Connect the cable to the engine and
be sure it is not kinked, bent sharp,
pulled taut, or interfered while
steering.
Do not bend the remote control
cable as sharp as its route diameter
is 300 mm (11.8 in) or less, or it
affects the service life of the cable
and the remote control lever
operation.