Honda BF135A Manual page 606

5) After installing the free piston, pour the fresh Automatic
Transmission Fluid (ATF) slowly up to the top of the piston
rod chamber of the cylinder comp.
6) Apply Automatic Transmission Fluid (ATF) to the new O-
ring and install it on the piston rod comp.
7) Apply Automatic Transmission Fluid (ATF) to the new O-
ring and install it on the cylinder cap.
8) With the piston rod comp. fully extended, install the piston
rod comp. slowly in the piston rod chamber of the cylinder
comp.
Loosely tighten the cylinder cap.
• Do not install the piston rod comp. by pushing it in the
piston rod chamber.
9) Tighten the cylinder cap to the specified torque using the
special tool as shown.
TOOL:
Pin wrench, 6 mm
TORQUE: 162 N . m (16.5 kgf . m, 119 lbf . ft)
10) Pour the fresh Automatic Transmission Fluid (ATF) in the
right and left trim cylinder chambers up to the top of the
trim cylinder chamber.
15-43
[1] CYLINDER
07SPA-ZW10100
COMP.
[4] O-RINGS
[1] PIN WRENCH,
6 mm
07SPA-ZW10100
[2] CYLINDER
CAP
[1] Pour slowly
up to the top
of the piston
rod chamber.
[2] PISTON
ROD
COMP.
[3]
CYLINDER
CAP
(ATF)
[1]
Pour slowly up to the
top of the trim cylinder
chamber.