Honda BF135A Manual page 467

22) Apply soapy water to the outer surface of the new 80 x 98
x 10 mm oil seal. Apply engine oil to the oil seal lip.
23) Using the special tools as shown, install the 80 x 98 x 10
mm oil seal on the crankshaft.
Drive in the oil seal so its upper side is 0.2 – 1.2 mm (0.01 –
0.05 in) deep from the surface.
TOOLS:
Driver
Oil seal driver attachment, 96
NOTICE
Drive in the oil seal with the part number on the oil seal
toward out.
24) Install the following pars.
– Crankcase/balancer case assembly (P. 12-8)
– Flywheel (P. 11-14)
– Oil pump (P. 11-11)
– Engine assembly (P. 7-6)
– Cylinder head assembly (P. 10-32)
– L./R. engine under covers (P. 4-14)
– Engine cover (P. 4-2)
13-26
[1]
DRIVER
07749-0010000
07749-0010000
07ZAD-PNA0100
[3]
OIL SEAL INSTALLATION DEPTH:
0.2 – 1.2 mm
(0.01 – 0.05 in)
[2]
OIL SEAL DRIVER
ATTACHMENT,96
07ZAD-PNA0100
[4] CRANKSHAFT
[5]
80 x 98 x 10 mm
OIL SEAL