Honda BF135A Manual page 167

BF135A•BF150A
5. Secure the extension wire as shown with the band.
6. Connect the extension wire to the HDS pocket tester.
7. Install the electric part cover and the engine cover in
the reverse order of removal.
EXTENSION WIRE
OF TESTER
WIRE BAND
• TO CLEAR DTC
1. Remove the engine cover and the electric part cover.
2. Connect the HDS pocket tester to the data link con-
nector (DLC).
3. Turn the ignition switch ON.
4. Clear the DTC using the HDS pocket tester.
Refer to the HDS pocket tester's operation manual for
how to use the HDS pocket tester.
• When abnormality remains in the system, the DTC
cannot be cleared as the ECM continues self-diag-
nosis.
• FINAL PROCEDURE
(AFTER TROUBLESHOOTING)
1. Clear the DTC.
2. Disconnect the HDS pocket tester wire from the data
link connector.
3. Install the cap on the under cover front bracket.
4. Install the electric part cover and the engine cover.
5-14