9) Remove the following bolts and washers from the underside of the mounting case.
• 8 x 100 mm flange bolt (1)
• 10 x 80 mm flange bolt (1)
• 10 x 110 mm flange bolts (2)
• 12 x 70 mm hex. bolt (1)
• 12 x 130 mm hex. bolts (2)
• 12 mm washers (3)
10) Lift up the engine assembly slowly and remove it from the mounting case.
NOTICE
• Be sure that the hoist hooks are set on the three engine
hangers securely.
• Lift up the engine assembly while holding the engine
vertically.
11) Remove the two dowel pins, mounting case gasket, exhaust guide gasket and the oil pump rubber.
[9]
MOUNTING
CASE GASKET
[8]
OIL PUMP RUBBER
[7]
14 x 20 mm
DOWEL PIN
7-4
[6]
12 x 70 mm
HEX. BOLT
10 x 80
10 x 110 (2)
[5]
12 x 130 mm
HEX. BOLT (2)
8 x 100
[1]
ENGINE ASSEMBLY
[2]
10 x 16 mm
DOWEL PIN
[3]
EXHAUST GUIDE
GASKET
[4]
12 mm WASHER (3)