Anode Metal/Water Screen - Honda BF135A Manual

18. ANODE METAL/WATER SCREEN

a. REMOVAL/INSTALLATION
Anode metal/water screen removal/installation can be made with the gear case mounted on the outboard motor.
[1]
5 x 50 mm OVAL SCREW
1 N . m (0.1 kgf . m, 0.7 lbf . ft)
[2]
6 x 50 mm HEX. BOLT
[11]
L. WATER SCREEN
INSPECTION:
Check for the clogged
water through hole
before installation.
14-88
[3]
ANODE METAL (2)
INSPECTION:
Replace the anode metal if
it is corroded excessively.
[10]
GEAR CASE ASSEMBLY
[4]
5.5 x 1.5 mm O-RING
[4]
5.5 x 1.5 mm O-RING
Do not reuse.
[9]
OIL DRAIN BOLT
Do not reuse.
[5]
OIL LEVEL BOLT
3.4 N . m (0.35 kgf . m, 2.5 lbf . ft)
[6]
5 mm SELF-
LOCKING NUT
[8]
6 mm SELF-
LOCKING NUT
[7]
R. WATER SCREEN
INSPECTION:
Check for the clogged
water through hole
before installation.
3.4 N . m (0.35 kgf . m, 2.5 lbf . ft)