Table of Contents
Advertisement
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
Ethernet Media Configuration Overview
Table 10: Valid Ethernet Media Configuration Settings for CTP
Speed
Autoneg Status
1000
ON
100
OFF
10
OFF
32
***
after the system reboots.
***
Are you sure? y[n]:
When prompted, specify a value for the protocol ID for data packets in the range
4.
2-254. The default value is 46.
To configure a CTP Bndl OAM port (IPv6):
From the Main Menu, select 5) Node Operations.
1.
Select 3) Configure network settings.
2.
Select 7) CTP Bndl OAM port (IPv6).
3.
When prompted, specify a port number for OAM packets in the range 2 through 254.
4.
The default value is 16.
You can configure the CTP Ethernet media to autonegotiate and set the speed to either
100 or 10 Mbps. By default, autonegotiation is enabled and the speed is to 1000 Mbps.
If you choose to disable autonegotiation, the system prompts you to configure the desired
speed.
The Ethernet configurations on CTP must match the configuration of the connected
router or switch. Mismatched configurations, such as setting the CTP system to
autonegotiate and the router to full duplex, will result in a misconfiguration and dropped
packets. You must disable Cisco Discovery Protocol on the Fast Ethernet port connected
to the CTP system.
Table 10 on page 32
lists the valid Ethernet media configuration settings that CTP Series
supports.
NOTE:
The CTP system supports only full duplex mode.
Mode (Duplex)
Full
Full
Full
MTU (up to 1500)
any
any
any
Copyright © 2018, Juniper Networks, Inc.
Advertisement
Table of Contents
