Table of Contents
Advertisement
Table 27: CTP Bundle T1 and E1 Port Parameter Settings in CTPView
Field
Port Description
I/F Type
T1/E1 Choice
Fractional
T1 Line Coding
Framing Mode
Copyright © 2018, Juniper Networks, Inc.
To configure T1 and E1 port parameters for CTP bundles using CTPView:
In the side pane, select Bundle > Configuration.
1.
Run your mouse over the Display and Select an Existing Bundle bar.
2.
In the table of bundles, select the bundle that you want to modify.
3.
Under Port Options, configure the parameters as described in
4.
The options vary depending on whether the bundle is T1 or E1 and whether fractional
T1 or E1 is configured.
Click Click to Submit Bundle AND Port Changes.
5.
Function
Specifies a description for the port.
Specifies the daughter card as the
interface type.
Specifies the type of interface.
Specifies whether the card is fractional.
For T1 interfaces, specifies the T1
encoding method used on this bundle.
For fractional T1, ESF is the only option
supported.
With ESF framing, the frame
synchronization, data link, and CRC
framing bits are passed across the IP
network untouched.
Chapter 2: Configuring CTP Bundles
Table 27 on page
Your Action
Enter a description of up to 64
alphanumeric characters. Do not use the
following characters:
( ; ' " ) ]
Select DCARD.
Select one:
T1
E1
Select one:
DISABLED—Card is not fractional.
ENABLED—Card is fractional.
Select one:
B8ZS
AMI
67.
67
Advertisement
Table of Contents
