Juniper CTP Series Manual page 170

Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
Table 64: BERT Parameter Settings in CTPView
Field Function
BERT Specifies whether this bundle acts as the BERT
Injection transmitter. If the bundle is the BERT transmitter,
specifies the direction in which it transmits test data.
BERT Specifies whether this bundle acts as the BERT receiver.
Reception If the bundle is the BERT receiver, specifies the direction
from which it receives test data.
The BERT receiver does not disrupt the existing data flow
in either direction.
Patterns Specifies the type of BERT pattern.
BERT patterns are compatible with the external BERT
equipment that you are using. All patterns except 2^31-1
are compatible with the Fireberd 6000.
When you set up a bidirectional end-to-end BERT, you
must configure the same pattern on both bundles.
Update Rate Specifies the rate at which CTPView checks the status
of the BERT and updates the synchronization status and
counters.
Inject Error The BERT transmitter injects an error into the pattern to
verify that an end-to-end BERT has been established.
Related
Documentation
164
BERT Testing for CTP Bundles Overview on page 158
Displaying BERT Status and Counters for CTP Bundles (CTPView) on page 167
Your Action
Select one:
Disabled—Disables BERT transmission on this
bundle.
Tx to Net—BERT pattern is injected toward the
IP network. User data transmitted in the direction
of the IP network is replaced with the BERT
pattern.
Tx to I/F—BERT pattern is injected toward the
serial interface. User data transmitted in the
direction of the IP network is replaced with the
BERT pattern.
Select one:
Disabled—Disables BERT reception on this
bundle.
Rx from Net—BERT pattern is received from the
network.
Rx from I/F—BERT pattern is received from the
interface.
Select one:
MARK
ALT
511
2047
2^15-1
2^20-1
2^23-1
2^29-1
2^31-1
2^4-1
Select the number of seconds.
Click the button to inject an error into the pattern.
The Error Cnt should increment by one.
Copyright © 2018, Juniper Networks, Inc.