Table of Contents
Advertisement
CHAPTER 7
Configuring Diagnostic Testing for CTP
Bundles
Configuring Serial Loops for CTP Bundles (CTPView)
Copyright © 2018, Juniper Networks, Inc.
Configuring Serial Loops for CTP Bundles (CTPView) on page 161
Configuring Serial Loops for CTP Bundles (CTP Menu) on page 162
Configuring BERT Testing for CTP Bundles (CTPView) on page 163
Configuring BERT Testing for CTP Bundles (CTP Menu) on page 165
Serial loops will run on transparent circuits only if the transparent circuits use the SD and
RD signals to transport data.
To configure serial loops using CTPView:
In the side pane, select Bundle > Diagnostics.
1.
Click Bit Error Rate Tester.
2.
Run your mouse over the MouseOver to Select a Port to Display bar.
3.
A list of bundles configured on the CTP device appears.
In the table of bundles, select the bundle for which you want to configure a serial loop.
4.
Configure the serial loop as described in
5.
Table 62 on page
162.
161
Advertisement
Table of Contents
