Table of Contents
Advertisement
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
Table 35: CTP Bundle Multiservice TDC Port Parameter Settings in the CTP Menu
Field
Mode
Src/Dest
NRZ/Rate
IRIG Output Level
See Also
Configuring Multiservice 4WTO Mode Port Parameters for CTP Bundles (CTP Menu)
84
Function
Specifies that the bundle will run in TDC
mode.
Specifies the direction of the circuit.
Specifies the data rate on the IP
connection.
Specifies the output level.
Note the following information about the
values:
0—There is no output.
128—Unity gain, which means there is
no attenuation or gain.
255—Gain is 2:1.
Serial Multiservice Interface Module Overview on page 5
Before you begin:
Disable the bundle before you modify the bundle options.
To configure Multiservice 4WTO mode port parameters using the CTP Menu:
From the CTP Main Menu, select 1) Bundle Operations.
1.
Select 1) CTP.
2.
Select a bundle from the list. The bundle port must have a 4WTO daughter card
3.
installed.
If you select an active bundle, you are prompted to disable the bundle before
configuring it.
Select 3) Port Config.
4.
Select 2) Interface.
5.
Your Action
Select TDC/IRIG.
Select one:
Src (signal enters CTP)—End of the
circuit that receives NRZ/IRIG data.
Dst (signal exits CTP)—End of the
circuit that sends NRZ/IRIG data
toward the network.
Enter a number from 500 through
5,000,000 bps. The port speed must be
a multiple of 500 bps.
Enter a number from 0 through 255.
Copyright © 2018, Juniper Networks, Inc.
Advertisement
Table of Contents
