Table of Contents
Advertisement
Table 34: CTP Bundle Multiservice IRIG-B Port Parameter Settings in the CTP Menu (continued)
Field
Output High Level
Output Low Level
See Also
Configuring Multiservice TDC Mode Parameters for CTP Bundles (CTP Menu)
Copyright © 2018, Juniper Networks, Inc.
Function
This setting applies only if you set the
direction of the port to Tx.
Specifies the high output level, which is
measured in peak-to-peak voltage. This
setting is based on a 50-ohm
termination.
This setting applies only if you set the
direction of the port to Tx.
Specifies the low output level, which is
measured in peak-to-peak voltage. This
setting is based on a 50-ohm
termination.
Serial Multiservice Interface Module Overview on page 5
Before you begin:
Disable the bundle before you modify the bundle options.
To configure Multiservice TDC mode port parameters using the CTP Menu:
From the CTP Main Menu, select 1) Bundle Operations.
1.
Select 1) CTP.
2.
Select a bundle from the list.
3.
If you select an active bundle, you are prompted to disable the bundle before
configuring it.
Select 3) Port Config.
4.
Select 2) Interface.
5.
Select 1) Typeand set the type to Optional Interface: MultiSvc.
6.
Follow the onscreen instructions and configure the options as described in
7.
Table 35 on page
84.
Chapter 2: Configuring CTP Bundles
Your Action
Enter a number from 0.00 through 7.85
volts peak-to-peak.
Enter a number from 0.00 through 7.85
volts peak-to-peak.
83
Advertisement
Table of Contents
