Table of Contents
Advertisement
Table 37: CTP Bundle 4WTO Port Parameter Settings in CTPView (continued)
Field
I/F Mode
I/F Type
Channel Options
Output Level
Copyright © 2018, Juniper Networks, Inc.
Function
Specifies that the interface is connected
to a data communication equipment
(DCE) device.
Specifies the daughter card as the
interface type.
Specifies the voice channel or channels
to enable on the 4WTO daughter card.
Each CTP port with the daughter card
installed can support either one or two
channels.
Specifies the output level for the 4WTO
daughter card.
Note the following information about the
values:
0—Gain is 2:3 (signal is attenuated
33% or 1.8 dB).
25—Unity gain, which means there is
no attenuation or gain.
255—Gain is 4:1 (signal is amplified
400% or 6 dB).
Intermediate values are derived with
linear interpolation. The actual gain
depends on the impedance of the
attached device.
Chapter 2: Configuring CTP Bundles
Your Action
Select DCE.
Select DCARD.
Select one:
Channel 0—Enables only channel 0.
Channel 1—Enables only channel 1.
Dual Channel—Enables both channel
0 and channel 1.
Enter a number from 0 through 255.
87
Advertisement
Table of Contents
