Table of Contents
Advertisement
Related
Documentation
Configuring Adaptive Clocking for CTP Bundles (CTP Menu)
Table 53: CTP Bundle Adaptive Clocking Settings in the CTP Menu
Field
Set to Defaults
AGGR Seconds/Calc
Copyright © 2018, Juniper Networks, Inc.
Adaptive Clocking Overview for CTP Bundles on page 7
The adaptive clocking configuration allows you to modify attributes that affect the
adaptive clocking algorithm. The default settings are acceptable for most applications.
We recommend that you change these settings only with the assistance of JTAC.
Before you begin:
Disable the bundle before you modify the bundle options.
To configure adaptive clocking for CTP bundles using the CTP Menu:
From the CTP Main Menu, select 1) Bundle Operations.
1.
Select 1) CTP.
2.
Select a bundle from the list.
3.
If you select an active bundle, you are prompted to disable the bundle before
configuring it.
Select 3) Port Config.
4.
Select 3) Clock Config.
5.
Select 1) Port Clock Config.
6.
Select Set Adaptive Parameters.
7.
Configure the options as described in
8.
Function
Sets the adaptive clocking configuration
to the default settings.
Specifies the time period during initial
start of adaptive clocking during which
packet samples that are experiencing the
least delay through the network are
collected. These samples are used for
aggressive state calculations.
Chapter 2: Configuring CTP Bundles
Table 53 on page
117.
Your Action
Select Set to Defaults.
Enter a number from 3 through 200
seconds.
117
Advertisement
Table of Contents
