Table of Contents
Advertisement
Table 22: CTP Bundle Serial Port Parameter Settings in the CTP Menu
Field
Port descriptor text
Interface
Type
Mode
Copyright © 2018, Juniper Networks, Inc.
If you select an active bundle, you are prompted to disable the bundle before
configuring it.
Select 3) Port Config.
4.
Configure the options as described in
5.
Function
Specifies a description for the port.
Displays the menu used to configure the
interface type, mode, and encoding.
Specifies the electrical standard used on
the serial interface.
You can install the following optional
daughter cards on a serial interface:
T1/E1 (CTP1000 and CTP2000 series)
4WTO (CTP1000 and CTP2000
series)
IRIG-B (CTP2000 series only)
Multiservice Daughter Cards (CTP
2000 and CTP150 series)
Specifies that the interface is connected
to a data communication equipment
(DCE) device or to a data terminal
equipment (DTE) device.
Chapter 2: Configuring CTP Bundles
Table 22 on page
55.
Your Action
Enter a description of up to 64
alphanumeric characters. Do not use
the following characters:
( ; ' " ) ]
Select 2) Interface.
Select one:
OFF—Do not set the interface type to
OFF.
EIA-530
EIA-530A
RS-232
V.35
Optional Interface
Select one:
DCE—The interface is connected to
a DCE device.
DTE—The interface is connected to
a DTE device.
55
Advertisement
Table of Contents
