Table of Contents
Advertisement
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
See Also
Configuring 4WTO Port Parameters for CTP Bundles (CTPView)
Table 37: CTP Bundle 4WTO Port Parameter Settings in CTPView
Field
Port Description
86
Serial Multiservice Interface Module Overview on page 5
Configuring 4WTO Daughter Cards to Interoperate with Multiservice Interface Modules
(CTP Menu)
For CTP bundles, you can configure a 4WTO daughter card installed on a serial interface
module.
You can set up 4WTO daughter cards to interoperate with Multiservice Interface modules.
Interoperability of Multiservice Interface modules with 4WTO daughter cards requires
the following:
Firmware revision 4 or later on the 4WTO daughter card.
CTPView releases 3.4R4 or 4.x.
CTPOS release 6.0 or later.
Channel 1 cannot be configured as the channel option.
Before you begin:
Log in to the CTPView software at least at the Net_Admin level.
Connect the CTPView server to the CTP device for which you want to configure bundles.
To configure port parameters for 4WTO daughter cards for CTP bundles using CTPView:
In the side pane, select Bundle > Configuration.
1.
Run your mouse over the Display and Select an Existing Bundle bar.
2.
In the table of bundles, select the bundle that you want to modify.
3.
Under Port Options, configure the parameters as described in
4.
Click Click to Submit Bundle AND Port Changes.
5.
Function
Specifies a description for the port.
Table 37 on page
Your Action
Enter a description of up to 64
alphanumeric characters. Do not use the
following characters:
( ; ' " ) ]
Copyright © 2018, Juniper Networks, Inc.
86.
Advertisement
Table of Contents
