Table of Contents
Advertisement
Table 21: CTP Bundle Serial Port Parameter Settings in CTPView (continued)
Field
I/F Mode
Serial Encoding
TDM Function
TDM Rate
Copyright © 2018, Juniper Networks, Inc.
Function
Specifies that the interface is connected
to a data communication equipment
(DCE) device or to a data terminal
equipment (DTE) device.
Specifies the serial encoding method
used on this bundle.
When you change the encoding method,
the clocking configuration changes to
the default configuration for the
encoding method that you select.
This option is used only for TDM/TDC
operation. See
"Configuring the
High-Speed CTP Bundle for TDM/TDC
Operation (CTPView)" on page
This option is used only for TDM/TDC
operation. See
"Configuring the
High-Speed CTP Bundle for TDM/TDC
Operation (CTPView)" on page
Chapter 2: Configuring CTP Bundles
Your Action
Select one:
DCE—The interface is connected to a
DCE device.
DTE—The interface is connected to a
DTE device.
Select one:
NRZ—Nonreturn to zero (NRZ) line
encoding.
ISOCH—Isochronous encoding.
Isochronous encoding does not provide
or embed the clock in the data.
CDI—Conditioned diphase. Conditioned
diphase encoding recovers and embeds
the clock in the data signal. CDI
encoding provides a speed of up to
4608 KBps.
TDM—Additional data is interleaved
with the port's serial data. This option
is used on TDM/TDC high-speed ports
and is available only on
even-numbered ports on a CTP 2000
serial module. See
High-Speed CTP Bundle for TDM/TDC
Operation (CTPView)" on page
TRANS8—Extension of the TRANS
encoding. Compared with TRANS
encoding, which sends four signals in
each direction, with TRANS8 encoding,
bandwidth is doubled and eight signals
can be sampled and transported. This
allows signals to be sent from
additional interfaces that were not
supported in TRANS encoding. </para>
62.
62.
"Configuring the
62.
53
Advertisement
Table of Contents
