Configuring Multiservice Tdc Mode Parameters For Ctp Bundles; (Ctpview) - Juniper CTP Series Manual

Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
See Also
Configuring Multiservice TDC Mode Parameters for CTP Bundles (CTPView)
Table 31: CTP Bundle Multiservice TDC Port Parameter Settings in CTPView
Field Function
Port Description Specifies a description for the port.
I/F Type Specifies the daughter card as the interface type.
Multi-Service Mode Specifies that the bundle will run in TDC mode.
TDC Source Specifies the direction of the circuit.
TDC NRZ Rate Specifies the NRZ data rate on the IP connection.
TDC IRIG Output Level Specifies the output level.
Note the following information about the values:
0—There is no output.
128—Unity gain, which means there is no
attenuation or gain.
255—Gain is 2:1.
76
Serial Multiservice Interface Module Overview on page 5
Before you begin:
Log in to the CTPView software at least at the Net_Admin level.
Connect the CTPView server to the CTP device for which you want to configure bundles.
To configure Multiservice TDC mode port parameters using CTPView:
In the side pane, select Bundle > Configuration.
1.
Run your mouse over the Display and Select an Existing Bundle bar.
2.
In the table of bundles, select the bundle that you want to modify.
3.
Under Bundle Options, configure the parameters as described in
4.
and click Click to Submit Bundle AND Port Changes.
Table 31 on page 76
Your Action
Enter a description of up to 64 alphanumeric
characters. Do not use the following characters:
( ; ' " ) ]
Select DCARD.
Select TDC.
Select one:
Source (signal enters CTP)—End of the circuit
that receives NRZ/IRIG data.
Destination (signal exits CTP)—End of the circuit
that sends NRZ/IRIG data toward the network.
Enter a number from 500 through 5,000,000 bps
in multiples of 500.
Enter a number from 0 through 255.
Copyright © 2018, Juniper Networks, Inc.