Table of Contents
Advertisement
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
Table 19: CTP Bundle Signaling Settings in CTPView (continued)
Field
Function
Signal Out -
Specifies the output signal depending
CTS/RTS
on whether the bundle is configured as
the DCE or the DTE:
DCE—CTS output signal.
DTE—RTS output signal.
Signal Out -
Specifies the output signal depending
DCD/LL
on whether the bundle is configured as
the DCE or the DTE:
DCE—DCD output signal.
DTE—LL output signal.
Signal Out -
Specifies the output signal depending
TM/RL
on whether the bundle is configured as
the DCE or the DTE:
DCE—TM output signal.
DTE—RL output signal.
46
Your Action
Select one:
Fixed - ON/0/Space/Low—Signal is turned on.
Fixed - OFF/1/Mark/High—Signal is turned off.
InBand - From Remote RL—Output signal is based on the state
of the RL input signal from the DCE or the TM signal from the
DTE.
InBand - From Remote RTS—Output signal is based on the state
of the RTS input signal from the DCE or the CTS signal from the
DTE.
InBand - From Remote DTR—Output signal is based on the state
of the DTR input signal from the DCE or the DSR signal from the
DTE.
InBand - From Remote LL—Output signal is based on the state
of the LL input signal from the DCE or the DCD signal from the
DTE.
Select one:
Fixed - ON/0/Space/Low—Signal is turned on.
Fixed - OFF/1/Mark/High—Signal is turned off.
InBand - From Remote RL—Output signal is based on the state
of the RL input signal from the DCE or the TM signal from the
DTE.
InBand - From Remote RTS—Output signal is based on the state
of the RTS input signal from the DCE or the CTS signal from the
DTE.
InBand - From Remote DTR—Output signal is based on the state
of the DTR input signal from the DCE or the DSR signal from the
DTE.
InBand - From Remote LL—Output signal is based on the state
of the LL input signal from the DCE or the DCD signal from the
DTE.
Select one:
Fixed - ON/0/Space/Low—Signal is turned on.
Fixed - OFF/1/Mark/High—Signal is turned off.
InBand - From Remote RL—Output signal is based on the state
of the RL input signal from the DCE or the TM signal from the
DTE.
InBand - From Remote RTS—Output signal is based on the state
of the RTS input signal from the DCE or the CTS signal from the
DTE.
InBand - From Remote DTR—Output signal is based on the state
of the DTR input signal from the DCE or the DSR signal from the
DTE.
InBand - From Remote LL—Output signal is based on the state
of the LL input signal from the DCE or the DCD signal from the
DTE.
Copyright © 2018, Juniper Networks, Inc.
Advertisement
Table of Contents
