Table of Contents
Advertisement
Table 19: CTP Bundle Signaling Settings in CTPView
Field
Function
Signal Out -
Specifies the output signaling delay in
Output Delay
packets.
Signal Out -
Specifies the output signal depending
DSR/DTR
on whether the bundle is configured as
the DCE or the DTE:
DCE—DSR output signal.
DTE—DTR output signal.
Copyright © 2018, Juniper Networks, Inc.
To configure signaling for CTP bundles using CTPView:
In the side pane, select Bundle > Configuration.
1.
Run your mouse over the Display and Select an Existing Bundle bar.
2.
In the table of bundles, select the bundle that you want to modify.
3.
Under Bundle Options, select Advanced Options Show to display advanced
4.
parameters and configure the parameters as described in
Click Click to Submit Bundle AND Port Changes.
5.
Your Action
Select the number of packets:
0
1
2
3
Select one:
Fixed - ON/0/Space/Low—Signal is turned on.
Fixed - OFF/1/Mark/High—Signal is turned off.
InBand - From Remote RL—Output signal is based on the state
of the RL input signal from the DCE or the TM signal from the
DTE.
InBand - From Remote RTS—Output signal is based on the state
of the RTS input signal from the DCE or the CTS signal from the
DTE.
InBand - From Remote DTR—Output signal is based on the state
of the DTR input signal from the DCE or the DSR signal from the
DTE.
InBand - From Remote LL—Output signal is based on the state
of the LL input signal from the DCE or the DCD signal from the
DTE.
Chapter 2: Configuring CTP Bundles
Table 19 on page
45.
45
Advertisement
Table of Contents
