How Basic Transparent Encoding Works - Juniper CTP Series Manual

Circuit to packet platform
Hide thumbs Also See for CTP Series:
Table of Contents

Advertisement

How Basic Transparent Encoding Works

Copyright © 2018, Juniper Networks, Inc.
Using Send Timing (ST) Clocking for Higher Speed Circuits with Transparent Encoding
on page 16
Configuring Transparent Encoding for CTP Bundles (CTP Menu) on page 60
Configuring Transparent Encoding for CTP Bundles (CTPView) on page 58
There are two modes of transparent encoding. They are Transparent 4 mode (TRANS)
and Transparent 8 mode (TRANS8). Transparent 8 mode is supported only on CTPOS
release 6.4 and later.
Transparent encoding mode 4 samples incoming data on four input signals (SD, TT, RTS,
and DTR), transports these signals across the IP network to the remote end of the circuit,
and sends the signals on four output signals (RD, RT, CTS, and DSR).
shows a simplified model of a transparent encoded circuit.
Figure 3: Simplified Model of a Transparent Encoded Circuit
Transparent Circuit
Pin
2
SD
24
TT
4
RTS
20
DTR
3
RD
17
RT
5
CTS
6
DSR
The signal sampling rate is based on the configured port rate. For example, if the port
rate is 128 Kbps, then the four signals are sampled at 128 KHz, which generates a packet
flow through the IP network of 512 Kbps (4 x 128 KHz). The smallest sampling rate
available is 5.3 μsec (approximately 192 KHz).
To prevent errors in transport, both ends of the circuit must be synchronized with each
other. You can achieve synchronization either by locking each CTP node to a common
reference or by enabling adaptive clocking on one end of the circuit.
Transparent 8 encoding is an extension of Transparent 4 encoding. Compared with
Transparent 4 encoding, which sends four signals in each direction, Transparent 8
encoding doubles the bandwidth and allows eight signals to be sampled and transported.
This allows signals to be sent from additional interfaces that were not supported in
Transparent 4 encoding, although the bandwidth usage will be higher.
Chapter 1: Overview of CTP Bundles
IP Network
Figure 3 on page 13
Transparent Circuit
Pin
RD
3
RT
17
CTS
5
DSR
6
SD
2
TT
24
RTS
4
DTR
20
13

Advertisement

Table of Contents
loading

Table of Contents