Juniper CTP Series Manual page 53

Table 19: CTP Bundle Signaling Settings in CTPView (continued)
Field Function
Signal In - Specifies the input signal depending on
RL/TM whether the bundle is configured as the
DCE or the DTE:
DCE—RL input signal.
DTE—TM input signal.
Signal In - Specifies the input signal depending on
RTS/CTS whether the bundle is configured as the
DCE or the DTE:
DCE—RTS input signal.
DTE—CTS input signal.
Signal In - Specifies the input signal depending on
DTR/DSR whether the bundle is configured as the
DCE or the DTE:
DCE—DTR input signal.
DTE—DSR input signal.
Signal In - Specifies the input signal depending on
LL/DCD whether the bundle is configured as the
DCE or the DTE:
DCE—LL input signal.
DTE—DCD input signal.
Copyright © 2018, Juniper Networks, Inc.
Your Action
Select one:
Unused—Input signals are ignored.
Demand Call - Active High—Signal is turned off.
Demand Call - Active Low—Signal is turned on.
Select one:
Unused—Input signals are ignored.
Demand Call - Active High—Signal is turned off.
Demand Call - Active Low—Signal is turned on.
Select one:
Unused—Input signals are ignored.
Demand Call - Active High—Signal is turned off.
Demand Call - Active Low—Signal is turned on.
Select one:
Unused—Input signals are ignored.
Demand Call - Active High—Signal is turned off.
Demand Call - Active Low—Signal is turned on.
Chapter 2: Configuring CTP Bundles
47