Table of Contents
Advertisement
Configuring Multiservice Audio Mode Port Parameters for CTP Bundles (CTP Menu)
Table 33: CTP Bundle Multiservice Audio Mode Port Parameter Settings in the CTP Menu
Field
Mode
Master/Slave
Dual Channel
Copyright © 2018, Juniper Networks, Inc.
Configuring Multiservice TDC Mode Parameters for CTP Bundles (CTP Menu) on page 83
Configuring Multiservice 4WTO Mode Port Parameters for CTP Bundles (CTP
Menu) on page 84
Before you begin:
Disable the bundle before you modify the bundle options.
To configure Multiservice audio mode port parameters using the CTP Menu:
From the CTP Main Menu, select 1) Bundle Operations.
1.
Select 1) CTP.
2.
Select a bundle from the list.
3.
If you select an active bundle, you are prompted to disable the bundle before
configuring it.
Select 3) Port Config.
4.
Select 2) Interface.
5.
Select 1) Type, and set the type to Optional Interface: MultiSvc.
6.
Follow the onscreen instructions and configure the options as described in
7.
Table 33 on page
79.
Function
Specifies that the bundle will run in audio
mode.
Specifies whether this end of the circuit
provides clocking or uses adaptive
clocking.
If the CTP devices at both ends of the
circuit are synchronized, you can
configure both ends as Master.
Two channels are supported—channel
0 and channel 1.
Enables or disables the use of both
channels.
Chapter 2: Configuring CTP Bundles
Your Action
Select AUDIO.
Select one:
Master—This end of the circuit provides
clocking.
Slave—This end of the circuit uses
adaptive clocking.
Select one:
Disable—Channel 0 is the only active
channel.
Enable—Both channel 0 and channel
1 are active.
79
Advertisement
Table of Contents
