Table of Contents
Advertisement
Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
Related
Documentation
Configuring Ethernet Media (CTP Menu)
Field
Please input the device to
configure the media for
34
recorded in both the
/var/log/messages
interface is down due to a non-full duplex condition. You are prompted to verify the cable
connection, speed, and duplex settings because the NIC link might be down.
Ethernet Media Configuration Overview on page 32
Configuring Ethernet Media (CTP Menu) on page 34
You can configure the CTP Ethernet media to autonegotiate the duplex mode and speed
and to set the speed to either 100 or 10 Mbps. The Ethernet configurations on the CTP
device must match the configuration of the connected router or switch. Mismatched
configurations, such as setting the CTP system to autonegotiate and the router to full
duplex, may result in a misconfiguration and dropped packets. You must disable Cisco
Discovery Protocol on the Fast Ethernet port connected to the CTP system.
To configure Ethernet interfaces on a CTP device using the CTP Menu:
From the Main Menu, select 5) Node Operations.
1.
Display the current Ethernet configuration by selecting 12) Config ethernet media.
2.
***
*** You are about to modify a system parameter that will require
*** a system reboot when complete.
***
*** If you decide to continue, the system will automatically
*** reboot upon leaving these menus.
***
*** Note: If these parameters are changed incorrectly,
***
system may not be reachable via the network
***
after the system reboots.
***
Are you sure? y[n]: y
Here is a list of the available ethernet devices and their descriptions:
eth0: 10/100/1000 Copper (right)
eth1: 10/100/1000 Copper (left)
Please input the device to configure the media for: eth0
Configure eth0 (e1000) for autonegotiation? [y] n
Configure eth0 for 100 Mbps [y] n
OK, setting speed to 10 Mbps.
Autonegotiation is enabled by default and the speed is set to 1000 Mbps
Function
Specifies the Ethernet port
directory and the syslog file stating that the
Your Action
Specify an Ethernet port from the list.
Copyright © 2018, Juniper Networks, Inc.
Advertisement
Table of Contents
