Configuring A Junos Space Appliance As The Primary Fmpm Node - Juniper JA2500 Hardware Manual

Juniper Networks JA2500 Junos Space Appliance Hardware Guide

Configuring a Junos Space Appliance as the Primary FMPM Node

114
Before you begin, do the following:
Ensure that the Junos Space Appliance is connected to a management console and
that the management device is powered on.
Ensure that the appliance is booted and displays the login prompt at the console.
Ensure that 100 GB free disk space is available before configuring a node as an FMPM
node.
Ensure that you have the following information available:
IPv4 address and subnet mask for the eth0 Ethernet interface
(Optional) IPv6 address and prefix for the eth0 Ethernet interface
IPv4 address of the default gateway
(Optional) IPv6 address of the default gateway
IPv4 address of the name server
(Optional) IPv6 address of the name server
Virtual IP (VIP) address of the FMPM nodes in IPv4 and IPv6 formats
The VIP address is used for communications between Junos Space nodes and FMPM
nodes. This IP address must be in the same subnet as the IP address assigned to the
eth0 Ethernet interface, and the VIP address must be different from the VIP address
used to access the Web GUI.
IPv4 address or URI of NTP source to synchronize time
(Optional) IPv4 address for the NAT trap
(Optional) IPv6 address for the NAT trap
(Optional) IPv4 port number for the NAT trap
(Optional) IPv6 port number for the NAT trap
This topic discusses the following tasks:
Configuring a Junos Space Appliance as the Primary FMPM Node on page 114
Configuring the eth1 Interface on page 121
You can configure a Junos Space Appliance as an FMPM node.
To configure the appliance as a standalone or primary FMPM node:
At the serial console login prompt, type the default username (
1.
Type the default password (
2.
You are prompted to change your password.
) and press Enter.
abc123
Copyright © 2018, Juniper Networks, Inc.
) and press Enter.
admin