Modifying The Ip Address Of The Eth1 Interface - Juniper JA2500 Hardware Manual

Juniper Networks JA2500 Junos Space Appliance Hardware Guide

Modifying the IP Address of the eth1 Interface

144
(Optional) To add or delete a static route, type
4.
Settings menu.
On the subsequent menu, you can do the following:
To add a static route, type
NOTE: We recommend that you ensure that the access to the gateway
is available before adding a static route.
To delete an existing static route, type the number corresponding to the static route
that you want to delete, and follow the prompts on the CLI.
Type A to apply all the changes that you made, or type
5.
Settings Menu without applying the changes.
You may need to modify the IP address of the eth1 interface of a Junos Space Appliance
when you move the Junos Space Appliance from one network to another.
NOTE: If you configure the eth1 interface, SSH is disabled on the eth0 and
the eth3 interfaces. You can then access the CLI of the Junos Space appliance
only through the eth1 interface.
To modify the eth1 interface settings:
On the Junos Space Settings Menu, type 6 to access the shell.
1.
You are prompted to enter your password.
Type your password and press Enter.
2.
The shell prompt appears.
At the shell prompt, type
3.
You are prompted to enter the IP address of the eth1 interface.
Type the IP address of the eth1 interface in dotted decimal notation and press Enter.
4.
The IP address can be in the same subnet as virtual IP (VIP) address or in a different
subnet. If the IP address is not in the same subnet as the VIP address, you are prompted
to enter the subnet mask and then the default gateway for the eth1 interface.
(Optional) Type the subnet mask for the eth1 interface in dotted decimal notation
5.
and press Enter.
at the prompt on the Change Network
3
1 and follow the prompts on the CLI.
and press Enter.
jmp_config
M to return to the Junos Space
Copyright © 2018, Juniper Networks, Inc.