Configuring The Device - Juniper SSG 5 Serial Hardware Installation

Chapter 3

Configuring the Device

NOTE:
ScreenOS software is preinstalled on the SSG 5 devices. When the device is
powered on, it is ready to be configured. While the device has a default factory
configuration that allows you to initially connect to the device, you need to perform
further configuration for your specific network requirements.
This chapter contains the following sections:
"Accessing a Device" on page 24
"Default Device Settings" on page 27
"Basic Device Configuration" on page 29
"Basic Wireless Configuration" on page 33
"WAN Configuration" on page 37
"Basic Firewall Protections" on page 39
"Verifying External Connectivity" on page 39
"Resetting a Device to Factory Defaults" on page 40
After you configure a device and verify connectivity through the remote network,
you must register your product at www.juniper.net/support/ so certain ScreenOS
services, such as Deep Inspection Signature Service and Antivirus (purchased
separately), can be activated on the device. After registering your product, use the
WebUI to obtain the subscription for the service. For more information about
registering your product and obtaining subscriptions for specific services, refer to
the Fundamentals volume of the Concepts & Examples ScreenOS Reference Guide for
the ScreenOS version running on the device.
23