Installing The Hard Disk; Figure 25: Installing A Hard Disk - Juniper JA2500 Hardware Manual

Installing the Hard Disk

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
To install a hard disk in the JA2500 appliance, do the following:
(Optional) Attach an ESD grounding strap to your bare wrist, and connect the strap
1.
to an external ESD point.
Remove the replacement hard disk from its antistatic bag.
2.
Slide the hard disk into the hard disk slot.
3.
Push the hard disk lever, as shown in
4.
to ensure that the hard disk is secured firmly in the slot.
Using a flat screwdriver, turn the screw clockwise to the locked position so that the
5.
notch in the screw is oriented vertically.

Figure 25: Installing a Hard Disk

When you install a replacement hard disk, the alarm shuts off when the new drive is
sensed and the red Hard Disk Fault LED on the new hard drive starts blinking, which
indicates that the drive is being rebuilt. When the drive is rebuilt, the red LED goes out.
Field-Replaceable Units on the JA2500 Junos Space Appliance on page 4
Installing and Removing JA2500 Junos Space Appliance Hardware Components on
page 151
Chapter 15: Replacing Components
Figure 25 on page 165, until it closes with a click
165