Configuring The Eth1 Interface - Juniper JA2500 Hardware Manual

Juniper Networks JA2500 Junos Space Appliance Hardware Guide

Configuring the eth1 Interface

112
To quit the configuration without applying the settings, type Q.
The Junos Space Settings Menu is displayed.
CAUTION: If you quit the configuration without applying the settings, then
all the settings are discarded.
From Junos Space Network Management Platform Release 14.1R1 onward, you can
configure the eth1 Ethernet interface as an administrative interface. Configure the eth1
interface when the Junos Space node reboots after the basic configuration is complete.
NOTE:
The eth1 interface must be configured separately for each node in a
multinode fabric.
If you configure the eth1 interface, SSH is disabled on the eth0 and the eth3
interfaces. You can then access the CLI of the Junos Space appliance only
through the eth1 interface.
To configure the eth1 interface:
On the Junos Space Settings Menu, type 6 to access the shell.
1.
You are prompted to enter your password.
Type your password and press Enter.
2.
The shell prompt appears.
At the shell prompt, type
3.
You are prompted to enter the IP address of the eth1 interface.
Type the IP address of the eth1 interface in dotted decimal notation and press Enter.
4.
The IP address can be in the same subnet as the virtual IP (VIP) address or in a different
subnet. If the IP address is not in the same subnet as the VIP address, you are prompted
to enter the subnet mask and then the default gateway for the eth1 interface.
(Optional) Type the subnet mask for the eth1 interface in dotted decimal notation
5.
and press Enter.
(Optional) Type the default gateway in dotted decimal notation and press Enter.
6.
and press Enter.
jmp_config
Copyright © 2018, Juniper Networks, Inc.