Table 4: Matrix For Ip Address Versions Supported On Devices - Juniper JA2500 Hardware Manual

Table 4: Matrix for IP Address Versions Supported on Devices

eth0
IPv4 Address IPv6 Address
Configured Not Configured
Configured Configured
Configured Not Configured
Configured Not Configured
Configured Not Configured
Configured Configured
Copyright © 2018, Juniper Networks, Inc.
by the IP address type of a managed device. For a connection initiated by a managed
device, Junos Space listens on both IPv4 and IPv6 addresses of the device management
interface (eth3). Therefore, a managed device can communicate with Junos Space by
using its IPv4 or IPv6 address.
NOTE: From Junos Space Network Management Platform Release 14.1R2
onward, you can configure Junos Space Ethernet interfaces with only IPv4
addresses, or both IPv4 and IPv6 addresses.
Junos Space supports managed devices based on the IP address type (that is, the IPv4
or IPv6 address) configured for the device management interface. You can configure an
IPv4 or IPv6 address for the device management interface. If the device management
interface is not configured, the IP address type of the node management interface (eth0)
is considered for communication with managed
support matrix for IPv4 and IPv6 address configurations on the device management
interface.
eth3
IPv4 Address
Not Configured
Not Configured
Configured
Configured
Not Configured
Configured
You can use the Ethernet interfaces as follows:
eth0—Use the eth0 interface to configure the virtual IP (VIP) address of a fabric and
the IP address of the node as well as to access the managed devices. The VIP address
and the IP address of the node should be on the same subnet.
The eth0:0 subinterface provides access to the Junos Space Network Management
Platform GUI. You can access the GUI by using the VIP address of the fabric.
eth1—Use the eth1 interface as an administrative interface of a Junos Space node. Use
SSH to access a Junos Space node through this interface. The eth0 interface and the
eth1 interface can be on different subnets.
If you configure eth1, you cannot access the Junos Space nodes using the eth0 interface.
You can access the CLI of the Junos Space node only through the eth1 interface.
Chapter 1: Appliance Overview
devices.Table 4 on page 5
IP Address of
Managed Devices
Supported by Junos
IPv6 Address Space
Not Configured IPv4
Not Configured IPv4 and IPv6
Not Configured IPv4
Configured IPv4 and IPv6
Configured IPv6
Configured IPv4 and IPv6
details the
5