Related
Documentation
Midmounting the Junos Space Appliance in a Two-Post Rack
Copyright © 2018, Juniper Networks, Inc.
Insert the two small screws in the recessed holes on the front rails and tighten.
4.
Slide the rear-mount rail brackets into the backs of the front rails on either side of the
5.
chassis and align with your rear equipment rack posts. Secure the rear-mount rail
brackets to your equipment rack with two rack mount screws each, as shown in
Figure 8 on page
81.
Figure 8: Front-and-Rear Mounting Recessed in a Rack
Insert locking screws on the sides of the rear-mount brackets to secure the front and
6.
rear mounting brackets in place.
Verify that the mounting screws on one side of the rack are aligned with the mounting
7.
screws on the opposite side and that the appliance is level.
The recessed position allows network and console cables to be routed through the sides
of the equipment rack and through the holes of the recessed front rails on either side of
the unit. This enables easy cable routing on the racks with limited cable management.
Front-and-Rear Mounting the JA2500 Junos Space Appliance Flush to a Rack on
page 79
Junos Space Appliance Rack Requirements on page 21
Midmounting the Junos Space Appliance in a Two-Post Rack on page 81
Tools and Parts Required to Install the Junos Space Appliance on page 77
This option is suitable for a two-post equipment rack. It allows the appliance to be
mounted so that there is even clearance on the front and rear of the rack.
Chapter 11: Installing the Appliance
81