Configuring The Eth1 Interface - Juniper JA2500 Hardware Manual

Juniper Networks JA2500 Junos Space Appliance Hardware Guide

Configuring the eth1 Interface

128
CAUTION:
then all the settings are discarded.
(Optional) If you have applied the settings, then type
12.
You are taken to the console login prompt.
The configuration of the appliance as a backup or secondary FMPM node is now complete.
NOTE: After you configure an FMPM node, you must add it to the Junos Space
fabric using the Junos Space Network Management Platform. For more
information, see the Adding a Node to an Existing Junos Space Fabric topic in
the Junos Space Network Management Platform Workspaces Feature Guide
(available at
http://www.juniper.net/techpubs/en_US/release-independent/junos-space/index.html
You can specify the name of the FMPM node when you add the node to the
Junos Space fabric.
From Junos Space Network Management Platform Release 14.1R1 onward, you can
configure the eth1 Ethernet interface as an administrative interface. For the FMPM node,
configure the eth1 interface when the node reboots after the basic configuration is
complete.
NOTE:
The eth1 interface must be configured separately for each node in a
multinode fabric.
If you configure the eth1 interface, SSH is disabled on the eth0 interface.
You can access the CLI of the Junos Space appliance only through the eth1
interface.
To configure the eth1 interface:
On the Junos Space Settings Menu, type 6 to access the shell.
1.
You are prompted to enter your password.
Type your password and press Enter.
2.
The shell prompt appears.
At the shell prompt, type
3.
You are prompted to enter the IP address of the eth1 interface.
If you quit the configuration without applying the settings,
and press Enter.
jmp_config
to quit.
Q
Copyright © 2018, Juniper Networks, Inc.
).