Replacing Components; Figure 15: Ac Power Supply Cord With Retainer; Replacing The Ac Power Supply Module On A Junos Space Appliance - Juniper JA2500 Hardware Manual

Related
Documentation
Copyright © 2018, Juniper Networks, Inc.
clip into the holes in the bracket on each side of the AC power cord inlet on the power
supply module, as shown in

Figure 15: AC Power Supply Cord with Retainer

Locate a replacement power cord with the type of plug appropriate for your
3.
geographical location.
If the AC power source outlet has a power switch, set it to the OFF position.
4.
Insert the power cord plug into an external AC power source outlet.
5.
If the AC power source outlet has a power switch, set it to the ON position.
6.
Push the power cord into the slot in the adjustment nut of the power cord retainer
7.
clip. Turn the nut until it is tight against the base of the coupler and the slot in the nut
is turned 90° from the top of the appliance, as shown in
Connect the power cord to the power supply module.
8.
Verify that the power cord does not block the air exhaust and access to device
9.
components, or drape where people could trip on it.
The Junos Space Appliance starts powering on when you supply power to the power
supply module. If the power supply cord is correctly installed, the LED on the power supply
module displays green when the power supply module is powering the appliance, and
amber when the power supply module is in standby mode (not powering the appliance).
AC Power Cord Specifications for Junos Space Appliances on page 23
AC Power Supply in Junos Space Appliances on page 24
Field-Replaceable Units on the JA2500 Junos Space Appliance on page 4
Replacing the AC Power Supply Module on a Junos Space Appliance on page 154
Figure 15 on page 153.
Chapter 15: Replacing Components
Figure 15 on page 153.
153