Performing Initial Configuration; Booting The Junos Space Appliance - Juniper JA2500 Hardware Manual

CHAPTER 13

Performing Initial Configuration

Booting the Junos Space Appliance

Copyright © 2018, Juniper Networks, Inc.
Booting the Junos Space Appliance on page 91
Configuring a Junos Space Appliance as a Junos Space Node on page 92
Configuring a Junos Space Appliance as a Standalone or Primary FMPM
Node on page 113
Configuring a Junos Space Appliance as a Backup or Secondary FMPM Node for High
Availability on page 123
Installing a Junos Space Image on a Junos Space Appliance by Using a USB
Drive on page 130
Powering Off the Junos Space Appliance on page 136
NOTE: If you have turned on power to the power supply module, then the
Junos Space Appliance starts booting automatically.
Before you begin booting the Junos Space Appliance, ensure that you have:
Connected the Junos Space Appliance to a management console.
Configured a console terminal or terminal emulation utility to use the following serial
connection parameters:
Baud rate: 9600 bits per second
Data: 8 bits
Flow control: None
Parity: None
Stop bits: 1
To boot the Junos Space Appliance, do the following:
Power on the management device (PC or laptop) that is connected to the appliance's
1.
console port.
91