Connecting A Junos Space Appliance To The Network; Figure 12: Dc Power Supply Grounding - Juniper JA2500 Hardware Manual

Related
Documentation

Connecting a Junos Space Appliance to the Network

Copyright © 2018, Juniper Networks, Inc.

Figure 12: DC Power Supply Grounding

Connect the grounding lug to the earthing terminal using the screw, as shown in
9.
Figure 12 on page 87.
Attach the plastic safety cover.
10.
Close the input circuit breaker.
11.
The Junos Space Appliance starts powering on when you supply power to the power
supply module. If the power supply module is correctly installed and functioning normally,
the LED on the power supply module displays green when the power supply module is
powering the appliance, and amber when the power supply module is in standby mode
(not powering the appliance).
DC Power Grounding Requirements and Warning on page 68
DC Power Supply in Junos Space Appliances on page 26
General Electrical Safety Guidelines and Warnings on page 61
DC Power Disconnection Warning on page 67
DC Power Wiring Sequence Warning on page 69
DC Power Wiring Terminations Warning on page 71
Preventing Electrostatic Discharge Damage on page 62
Though the Junos Space Appliance has four Ethernet interfaces, only three can be used;
one of the Ethernet interface is reserved for future use. On the JA2500 appliance, the
Ethernet interfaces that can be used are labeled
reserved for future use.
Chapter 12: Connecting the Appliance
, , and . The Ethernet interface is
0 1 3 2
87