Task 14H: Run The Switch Translations Audit A Second Time; Task 14I: Assign The Time Zone - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Task 14: Perform Initial DEFINITY AUDIX Administration
Task 14H: Run the Switch Translations Audit
a Second Time
This task is required for all installation scenarios.
You must run the Switch Translations audit a second time to update the DEFINITY
AUDIX system processes again with the new information you have administered.
1. With the cursor on the DEFINITY AUDIX command line, type audit
switch-translations and press
The system displays the Audit Results screen.
2. Press the
3. When the audit is complete (in a few seconds) proceed to Subtask 14I. If
the audit does not complete successfully, see DEFINITY AUDIX
System — Maintenance , 585-300-110.

Task 14I: Assign the Time Zone

This task is required for all installation scenarios.
Use the information on Worksheet C-6, Assign the Time Zone , to perform this
task.
1. With the cursor on the DEFINITY AUDIX command line, type change
switch-time-zone and press
RETURN
(F3) function key to begin the audit.
ENTER
RETURN
.
.
Issue 2 December 1996
3-23