Task 10: Finalize And Test The Hardware - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Task 10: Finalize and Test the Hardware

Task 10: Finalize and Test the
Hardware
This task is required for all installation scenarios.
1. Verify that the DEFINITY AUDIX system is in the ADX (AUDIX) state.
Standing to the right of the DEFINITY AUDIX assembly, reading from
bottom to top, the LCD should display ADX.
2. Log in to the DEFINITY AUDIX system at the terminal (both terminals if you
have installed more than one) to verify that the terminals and modems (if
applicable) are connected and set up correctly.
a. At the login prompt, type craft and press
b. Enter crftpw.
c. Enter one of the following:
prompt is not displayed, press
NOTE:
To send the information to the DEFINITY AUDIX system, the
key (located on the right side of your keyboard) must
RETURN
be pressed after you type a command or a response to a
prompt. On some keyboards, this key is labeled
instead of
RETURN
and an key (as on the 513 and 615 keyboards), use
ENTER
the key.
RETURN
The system responds with the Password prompt.
The system responds with the Enter terminal type prompt.
513 for a 513 BCT or 715 BCT; enter 513 also for a 610/615
BCT or a PC with a 513 emulation package. (Since 513 is the
default, you can just press
4410 for a 4410 or 5410 terminal; enter 4410 also for a
610/615 BCT or a PC with a 4410 emulation package.
4425 for a 4425 or 5425 terminal
5420 for a 5420 or 4415 terminal
g3-ma for a G3-MA terminal
If the terminals and modems (if applicable) are connected properly
and the options are set correctly, the system responds with the
AUDIX command line.
RETURN
once or twice.)
RETURN
. If your keyboard has both a
to select it).
RETURN
Issue 2 December 1996
. (If the login
ENTER
key
RETURN
2-33