Upgrade Checklist - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Upgrade Checklist

Upgrade Checklist
The following checklist lists, in recommended order, the upgrade tasks you may
need to perform. Use the information in the Upgrade Worksheet to determine
which tasks are necessary.
Task
1. Upgrade the Disk Drive, if
Necessary
2. Upgrade the Tape Drive, if
Necessary
3. Run Software Upgrade,
Steps 1 to 6.
4. Replace Multifunction
Board, If Necessary
5. Replace Alarm Board, if
Necessary
Comments
Necessary if the new
system needs greater than
40 hours of speech or the
old system has a 6-hr. disk.
The inclusion of digital
networking may also add
significant storage needs.
Necessary if the new
system will have a 1.05- GB
disk (since more than 40
hours of data may need to
be backed up).
You continue with step 7 of
the software upgrade after
any necessary hardware
installations are complete.
Necessary if:
Old MFB is a TN566
(without a B)
Or, if necessary, the
following three items are
true:
Digital networking is
purchased and more
than 10 voice ports are
required
Switch is G3V2/V3/V4
Necessary if both of the
following items are true:
Old alarm board is
2169
Message Manager will
be installed
Where Task is Described
Chapter 4 , DEFINITY
AUDIX System -
Maintenance ,
585-300-110.
This chapter in section,
Tape Drive Installation .
This chapter in section,
Software Upgrade.
This chapter in section,
Circuit Card
Replacement.
This chapter in section,
Circuit Card
Replacement.
Issue 2 December 1996
7-5