Task 14J: Reboot The Definity Audix System - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Task 14: Perform Initial DEFINITY AUDIX Administration

Task 14J: Reboot the DEFINITY AUDIX System

This task is required for all installation scenarios.
1. With the cursor on the DEFINITY AUDIX command line, type reset system
reboot and press
The system displays the Reset System Reboot screen.
2. Press the
During the DEFINITY AUDIX system reboot, the LCD displays the various
system states and the terminal screen displays a series of messages
about the reboot, including a login prompt. Do not log in yet.
3. Wait approximately 10 minutes for the DEFINITY AUDIX system to come
up to the AUDIX state (the screen will display
OLDTRACELOG=/var/spool/audix/oldtrace), then login as craft
(see Task 14A for the login procedure).
If the system has completed the reboot, the Status line on the screen
displays audix; otherwise, the Status line displays Initializing to AUDIX.
(You cannot continue until the Status line changes to audix.)
4. Once the reboot completes successfully, proceed to Subtask 14K: Run
the Switch Names Audit. Otherwise, note the state indicated on the LCD,
then see the corresponding troubleshooting procedures in DEFINITY
AUDIX
System — Maintenance , 595-300-110, before continuing.
.
RETURN
(F3) function key to begin the reboot.
ENTER
Issue 2 December 1996
3-25