Task 2: Gather Required Tools; Task 3: Review Safety Considerations - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Task 2: Gather Required Tools

Task 2: Gather Required Tools
To install an DEFINITY AUDIX system, you must have the following tools:
No. 1 or No. 2 Phillips screwdriver
Narrow width, flat blade screwdriver
1/4-inch nut driver (recommended)
Antistatic grounded wrist strap

Task 3: Review Safety Considerations

!
WARNING:
Electronic equipment can be damaged by electrostatic discharge. Do not
touch any electronic component unless you are properly grounded.
!
DANGER:
Do not touch the switch backplane while installing the DEFINITY AUDIX
system. The backplane contains dangerous voltages and current.
To prevent damage to the equipment and yourself, adhere to the following:
Make sure you are familiar with the procedures necessary to prevent
electrostatic damage to the equipment.
Properly ground a wrist strap.
Place the grounded wrist strap on your bare wrist. (The wrist strap must
contact your bare skin directly—do not wear it over your clothes.)
Do not remove the DEFINITY AUDIX System assembly from the
polyethylene bag until:
— Your wrist strap is on your wrist and properly grounded.
— You have made room in the switch carrier and you are ready to
If you need to work on the DEFINITY AUDIX System assembly — that is,
disassemble it — place the assembly on a grounded antistatic work mat.
insert the DEFINITY AUDIX System assembly in the carrier.
Issue 2 December 1996
1-3