Dcs Subscribers - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Task 22: Test the Call Answer and Voice Mail Features
f. Press
g. After listening to the message, press
3. Create a test Voice Mail message.
a. From the DEFINITY AUDIX session you are currently in, press
b. After the tone, speak a test message (for example "This is a test
c. When you have finished speaking the message, press
d. When prompted for a destination extension, enter the extension of
e. Press
f. Hang up.
4. Retrieve the test Voice Mail message.
a. Walk back over to the first test phone and check the MWI. It may
b. Call the DEFINITY AUDIX extension to retrieve the message.
c. Press
d. Press
e. After listening to the message, press
f. Hang up and, at the DEFINITY AUDIX administration terminal type

DCS Subscribers

If running in a DCS environment, complete the following steps to test the Call
Answer, Voice Mail, and Leave Word Calling features for each remote test
subscriber added in Task 21.
1. Create a test Call Answer message.
a. From one of the test phones, call the extension of the remote
b. Let the phone ring until the DEFINITY AUDIX system answers.
then press
2 0
the first test extension.
Voice Mail message.")
approve the message.
the first test phone and press
again to deliver now.
#
take a minute or two for the MWI to turn on. When it is on, proceed
to the next step. Otherwise, refer to the troubleshooting procedures
in DEFINITY AUDIX System — Maintenance , 585-300-110.
when prompted for your extension and when prompted for
#
your password. (There is no password assigned to this extension.)
then press
2 0
the second test extension.
status test and press
RETURN
operation run previously.
subscriber.
to listen to the message you recorded from
to delete the message.
D
*
to end the addressing.
#
to listen to the message you recorded from
to delete the message.
D
*
to check the results of the test tape
Issue 2 December 1996
.
1
to
#
4-11