Upgrades To R3.2; Upgrade Overview; Hardware - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Upgrades to R3.2

This chapter describes how to upgrade from previous releases of the DEFINITY
AUDIX system to R3.2.

Upgrade Overview

The DEFINITY AUDIX 3.2 system differs from earlier releases of the system in
ways that significantly affect the tasks you must perform in an upgrade.

Hardware

Hardware changes that affect upgrades follow:
Disk Drive
Tape Drive
Multifunction
Board
The DEFINITY AUDIX 3.2 system offers an optional
1.05- GB disk drive that allows up to 100 hours of voice
storage. Earlier releases of DEFINITY AUDIX had disk
drives that allowed a maximum of 6 or 40 hours of voice
storage.
The DEFINITY AUDIX 3.2 system offers a 600-MB tape
drive to accommodate the additional voice storage
available on the 1.05-GB disk drive. Earlier releases of
DEFINITY AUDIX had 160-MB tape drives.
The DEFINITY AUDIX 3.2 system runs on a TN566B or
TN567 multifunction board (MFB). Earlier releases of
DEFINITY AUDIX ran on TN566 and TN566B MFBs.
7
Issue 2 December 1996
7-1