Hardware Installation
Task 6: Connect the Alarm Board Cable
The Alarm Board cable has three connectors available for outside connections:
Alarm Origination/Remote Maintenance Access
Local Area Network (LAN) used for I
Reserved
Refer to Figure 2-4, Alarm Board Cable Connections, to connect the cables
:
Figure 2-4. Alarm Board Cable Connections
Alarm Origination/Remote Access Connection
This task is required for all installation scenarios.
Alarm Origination/Remote Maintenance Access is normally set up through the
internal AUDIX modem. It can also be set up through the switch in addition to, or
instead of through the AUDIX modem. In either case, perform the connections
described in the DEFINITY AUDIX Connection section below. If Alarm
Origination/Remote Maintenance Access through the switch is indicated on
Worksheet C-9, also make the connections described in the SWITCH Connection
section.
2-10
Issue 2 December 1996
GROUP 300
SWITCH
ALB
CABLE
ALARM
BOARD
RS-232
MFB
PORT B
Y
CABLE
MULTI-
FUNCTION
BOARD
PORT A
TM
Message Manager (IMM)
NTUITY
TO CROSS-
CONNECT FIELD I/O
CABLE
RJ45 TO LOCAL AREA NETWORK
(RESERVED)