Worksheets Needed; Task 26: Add The Initial Subscribers - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Initial Subscriber Administration

Worksheets Needed

Before beginning these tasks, make sure you have worksheet C-8, Add
Subscribers , from Planning for the DEFINITY AUDIX System , 585-300-601. The
Project Manager or Software Specialist should have provided this worksheet.

Task 26: Add the Initial Subscribers

This task is required for all installation scenarios.
This task describes the basic procedure for adding subscribers via the
Subscriber screen. The basic procedure includes entering only subscriber
names and extensions (using default values for all other parameters). Check
Worksheet C-8, Add Subscribers to see if any subscribers will have special
administration (other than their name and extension). If so, refer to Chapter 3,
Ongoing Administration , in DEFINITY AUDIX System — Administration ,
585-300-507, for adding and administering the subscribers. Otherwise, continue
with the following procedure.
NOTE:
You may also add subscribers via the AUDIX Administration and Data
Acquisition Package (ADAP) addsub command. This is described in
AUDIX Administration and Data Acquisition Package, 585-300-502.
However, before adding subscribers via ADAP, make sure the DEFINITY
AUDIX system administrator has installed and administered the ADAP
system.
The procedure for adding subscribers via the DEFINITY AUDIX Subscriber
screen is as follows.
1. With the cursor on the DEFINITY AUDIX command line, enter add
subscriber.
5-2
Issue 2 December 1996