Table of Contents
Advertisement
Stand-alone node set-up
............................................................................................................................................................................................................................................................
Note:
These alarms will be cleared in
installation
........................................................................................................................................................................................................................
17
If FAULT LEDs remain lit on the VLNC50 or VLNC52 circuit pack log into shelf and
retrieve alarms using the RTRV-ALM command and refer to the Alcatel-Lucent 1850
Transport Service Switch (TSS-5) Maintenance and Trouble-Clearing Guide, 365-372-
402R5.1, for procedures to clear the alarm.
........................................................................................................................................................................................................................
18
Any other alarms will be cleared later on in
"Stand-alone installation
........................................................................................................................................................................................................................
19
Check off the appropriate box in
Table 5-2 LBOs for OC-n/STM-n lines
Optics
Long Reach Optics
Intermediate Reach (IR)
Optics
Short Reach (SR) Optics
OC3/STM1 CWDM-LR
OC12/STM4 CWDM-LR
E
O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
5 - 8
There will still be solid FAULT and CR/MJ LEDs on the SYSCTL at this time.
testing".
testing".
Circuit Pack PTM
OM155 1.3LR1
OM622 1.3LR1
OM622 1.5LR1
OM155 1.3IR1
OM622 1.3IR1
OM155 1.3SR1
OM155 wavelengths
1471,1491,1511,1531
,1551,1571,1591,&
1611
OM622 wavelengths
1471,1491,1511,1531
,1551,1571,1591,&
1611
S
F
T E P S
"Clearing alarms" (p. 6-8)
"Clearing alarms" (p. 6-8)
Table II-1, "Part II installation checklist" (p.
Allowable Receiver Range (dBm)
-10.0 to -34.0
-8.0 to -28.0
-8.0 to -28.0
-8.0 to -28.0
-8.0 to -28.0
-8.0 to -23.0
-9.0 to -28.0
-9.0 to -28.0
Circuit pack installation
of
Chapter 6, "Stand-alone
of
Chapter 6,
II-1).
365-372-403R5.1
Issue 1 November 2008
Advertisement
Table of Contents
