............................................................................................................................................................................................................................................................

VLNC35 standalone test

This procedure will verify the four electrical RJ-45 ports are working on the VLIU I/O

panel when the Alcatel-Lucent 1850 TSS-5 shelf is equipped with a VLNC35 circuit pack.

If the VLNC35 is equipped the optical PTMs these ports will be tested as well.

Connect the Front CIT cable between the PC and the CIT/RS 232 jack of the System

Controller and login to the shelf using the serial connection.

Identify the function group "C" that contains the VLNC35 (10/100T) circuit pack.

Identify the RJ45 patch panel on the associated VLIU with the function group "C"

identified above.

Connect the RJ45 cable from the first RJ45 port on the VLIU I/O panel to the ethernet port

on your PC.

Watch for the link LED to light on the PC's Ethernet card or wait for 30 seconds and then

disconnect the RJ45 cable from the VLIU I/O panel.

The Fault LED will start flashing on the VLNC35 circuit pack.

Verify that there is an inc. FE-LAN LOS alarm associated with the ethernet port where the

signal was removed. Use the Alarm List button on the CIT system view.

Select Configuration -> Update System... -> Update All.

Result:

Connect the RJ45 cable to the next jack on the VLIU I/O panel and repeat starting at

until all electrical ports have been tested.

365-372-403R5.1

Issue 1 November 2008

The flashing fault LED on the VLNC35 will clear.

Local equipment and cross-connect tests

Step

6 - 2 1

Table of Contents

Alcatel-Lucent 1850 Installation And System Turn-Up Manual page 147

Related Manuals for Alcatel-Lucent 1850

Related Products for Alcatel-Lucent 1850

Table of Contents