...................................................................................................................................................................................................................................

Overview

This chapter provides a procedure for replacing LC-type LBOs.

Procedure

Proceed as follows to replace LC-type LBOs:

...................................................................................................................................................................................................

Depress both beams (upper and lower) simultaneously and remove the LBO.

...................................................................................................................................................................................................

Insert the new LBO until a small "click" is heard. Pay attention to the correct direction

as shown in the figure below.

N D

O F

...................................................................................................................................................................................................

Figure

Figure A-3 LBO replacement

A-24

S T E P S

Depress Beam

to Remove Buildout

Install

Alcatel-Lucent - Proprietary

See notice on first page

NC2510g-097

365-374-179R10.0

Issue 2, June 2009