Alcatel-Lucent 1850 Installation And System Turn-Up Manual page 117

Transport service switch (tss-5) | release 5.1
Hide thumbs Also See for 1850:
Table of Contents

Advertisement

Stand-alone node set-up
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
3
If applicable, fully insert the VLNC52 circuit pack into main 1 or main 2.
Note:
board. Refer to
configurations for the VLNC52.
Note:
circuit pack, slide the circuit pack into the slot until it is fully seated. Then close the
faceplate latch.
Result:
off, indicating successful installation.
........................................................................................................................................................................................................................
4
If applicable, fully insert the VLNC60 circuit pack into either main 1 or main 2. Refer to
Table 5-1, "Main slot VLIU compatibility" (p. 5-2)
the VLNC60.
Note:
circuit pack, slide the circuit pack into the slot until it is fully seated. Then close the
faceplate latch.
Result:
off, indicating successful installation.
........................................................................................................................................................................................................................
5
If applicable, fully insert the VLNC61 circuit pack into either main 1 or main 2. Refer to
Table 5-1, "Main slot VLIU compatibility" (p. 5-2)
the VLNC61.
Note:
circuit pack, slide the circuit pack into the slot until it is fully seated. Then close the
faceplate latch.
Result:
off, indicating successful installation.
........................................................................................................................................................................................................................
6
If applicable, fully insert the VLNC64 circuit pack into either main 1 or main 2. Refer to
Table 5-1, "Main slot VLIU compatibility" (p. 5-2)
the VLNC64.
............................................................................................................................................................................................................................................................
365-372-403R5.1
Issue 1 November 2008
The VLNC52 can occupy both main slots when equipped with a VLIU10 I/O
Table 5-1, "Main slot VLIU compatibility" (p. 5-2)
Unlatch the circuit pack and using a gentle steady pressure on both ends of the
The circuit pack FAULT LED lights for approximately 2 minutes then goes
Unlatch the circuit pack and using a gentle steady pressure on both ends of the
The circuit pack FAULT LED lights for approximately 30 seconds then goes
Unlatch the circuit pack and using a gentle steady pressure on both ends of the
The circuit pack FAULT LED lights for approximately 30 seconds then goes
Circuit pack installation
for appropriate slot
for appropriate slot configurations for
for appropriate slot configurations for
for appropriate slot configurations for
5 - 5

Advertisement

Table of Contents
loading

Table of Contents