Alcatel-Lucent 1850 Installation And System Turn-Up Manual page 143

Transport service switch (tss-5) | release 5.1
Hide thumbs Also See for 1850:
Table of Contents

Advertisement

Stand-alone installation testing
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
12
Repeat entire procedure on each of the remaining DS1/E1 (VLNC50/52) tributaries of
function group "A."
........................................................................................................................................................................................................................
13
At the NE system level view, select Configuration -> Update system and choose update
all.
Result:
from the DSX-1.
........................................................................................................................................................................................................................
14
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
DS3/E3 testing procedure
Perform the following steps to verify backplane cabling to GRP B function slot of the
VLIU access panel.
Cabling to DS3/E3 connectors located on the VLIU access panel are located on the front
panel labeled "GRP B." If a VLNC50/52 circuit pack is installed, DS3/E3 cabling will
need to be tested.
This procedure requires the use of a DS3/E3 test set.
Note:
that will connect from the Mini-BNC to the test set is required to complete this testing.
Note:
connections.
........................................................................................................................................................................................................................
1
Set the DS3/E3 test set to transmit and receive a valid M13 or framed E3 signal.
........................................................................................................................................................................................................................
2
Connect an input and output cable from the DS3/E3 test set to the associated DS3/E3 port
of "GRP B" on the VLIU access panel.
........................................................................................................................................................................................................................
3
Enter a STS1/VC3 cross-connect to the port under test. To determine if a cross-connection
exists, View -> Cross-connections at the NE system view and select the DS3/E3 circuit
............................................................................................................................................................................................................................................................
365-372-403R5.1
Issue 1 November 2008
This command will remove alarms generated by removing the test signals
S
F
T E P S
The access panel requires Mini-BNC connectors for DS3/E3 inputs, a cable
If an error-free signal is not received, check DS3/E3 cabling for proper
Table II-1, "Part II installation checklist" (p.
Local equipment and cross-connect tests
II-1).
6 - 1 7

Advertisement

Table of Contents
loading

Table of Contents